快乐炸金花

快乐炸金花

Guangzhou Land Rover transportation facilities Co., Ltd

contact number: 400-900-3139

Fax: 020-36595168

Email: 2881854229@qq.com

Address of marketing center: 3a01, block C, Huijin Plaza, 770 Baiyun Avenue North, Baiyun District, Guangzhou

Factory address: 1601 Longjiao Road, Longhu village, Shijing street, Baiyun District, Guangzhou

What should be paid attention to in hot melt marking construction? Road marking manufacturer

Click: 171 date: September 19, 2020 Select font size: Small in large
 What should be paid attention to in hot melt marking construction? Road marking manufacturer

Road marking manufacturer Road marking is an important part of traffic facilities. Clear and complete road markings can give drivers and pedestrians a good reflection, can effectively reduce accidents and improve driving efficiency. So what should be paid attention to when the hot-melt marking paint is used for construction, so as to draw a clear and complete road marking? Please listen to the small editor.

Road marking manufacturers introduced the hot-melt coatings from petroleum resin EVA, PE wax, pigments, fillers and other materials, powder at room temperature, melting into a flow after coating to the road surface to form a solid film. It has the characteristics of full line shape, strong wear resistance, etc. it is widely used in highway and urban road because of its good reflective effect at night.

Matters needing attention in hot melt marking construction

1、 Ensure that the working face is clean and dry. It is recommended that the working face should be kept at air temperature Construction above 0 ℃ (for low temperature construction, please raise material temperature appropriately).

2、 Road marking manufacturer When the coating is melted, the temperature should be controlled within The performance of the hot-melt coating can be fully reflected when the melting temperature is 180-200 ℃ and the mixture is fully stirred and kept for 3-5 minutes.

3. The base oil treatment should be sufficient, after the bottom oil is completely dry, then line coating marking.

4. For the newly completed cement road, the construction shall be delayed for three months or the bottom oil treatment shall be conducted twice. Otherwise, it is easy for the marking to fall off.

5. In the construction of the road section with large traffic flow, after the primer is coated, please place a warning cap to prevent the wheel from rolling, take away the bottom oil and leave dust, otherwise, some markings will fall off.



Consultation hotline on Land Rover transport website: 400-900-3139

Road marking manufacturer Website address: http://hlsabu3.icu/

Land Rover transportation marketing company address: Baiyun Avenue North, Baiyun District, Guangzhou 3a01, block C, Huijin Plaza, 770

Address: Jiaohu Road, Longhu District, Guangzhou 1601 - Land Rover transport